|
KOOL-IT®; Radiator Flush is formulated with the highest quality additives.
These additives will circulate through the cooling system to remove scale, loose rust, mineral deposits
and combustion by-products from the coolant system and radiator of a car or truck. Radiators use coolants
(anti-freeze), water and other additives. Water contains minerals and ions that form deposits over time on the
metal surfaces of your cooling system and radiator. These deposits will reduce the heat transfer rate (which can
cause overheating), the deposits also can cause corrosion of the coolant system components and reduce the
efficiency and life of the anti-freeze. The longer you drive your vehicle without flushing the radiator and
replacing the coolant, the more likely that cooling system problems will arise. Extreme driving conditions, such
as; operation in hot climates, extended service intervals, stop and go driving, operation in mountainous areas,
speeds above 65 mph, towing, etc., increases the chances of harmful deposit formation in the cooling system.
BENEFITS:
- Quickly and safely removes scum, oily residue, sediments, rust, deposits and other degradation products from the cooling system of any car or truck
- Maximizes cooling system efficiency
- Contains corrosion inhibitors
- No acids
- Safe and easy to use
- Requires no neutralizers
- Safe for all cooling systems including aluminum
radiators
|
|
Directions For Use:
Never remove radiator cap if engine is still
hot. With engine cool, remove radiator cap, open radiator drain
petcock valve, drain fluid from system into proper container, close
radiator drain petcock valve. Add KOOL-IT Radiator Flush to cooling
system and fill with water. Replace radiator cap. Start engine,
turn heat on high, and run for 10 minutes. Stop the engine. Allow
engine to cool. Never remove radiator cap if engine is still hot.
Remove radiator cap. Open radiator drain petcock valve. Drain water
as before. Refill with water. Replace radiator cap. Start and run
engine for 5 minutes. Stop engine. Allow engine to cool. Never remove
radiator cap if engine is still hot. Remove radiator cap. Open radiator
drain petcock valve. Drain water as before. Fill radiator with recommended
anti-freeze and water mixture. Replace radiator cap. For best results,
always use KOOL-IT Supreme Coolant Treatment after flushing the
system. Use KOOL-IT Radiator Flush to effectively clean the cooling
system,
|
Now
Available in Flush & Protect Performance Pack!