Bio/Tech Engine Oil Protectant with LXE® Technology

FOR USE IN GASOLINE AND DIESEL ENGINES INCLUDING THOSE ENGINES WITH DIESEL PARTICULATE FILTERS

• Reduces oil and fuel consumption!
• Optimizes engine horsepower and performance
• Protects and extends oil life by 30%
• Improves fuel economy by reducing friction in your engine
• Reduces wear on metal components, thus increasing part life
• Improves anti-friction and anti-wear properties of ALL major oil brands to meet requirements of ALL vehicles, including older and high performance models
• Eliminates lifter and other objectionable noise on startup, especially in cold weather
• Ensures smoother running engines
• Reduces hot engine oil temperatures
• Gives improvement in friction and wear performance over major brands of motor oil
• Blends with ALL motor oils currently produced, including API; SJ, SK, SL, SM, SN – SN+, SN, CH-4, CI-4, CI-4+, CJ-4 – CK-4 motor oils.
• Helps reduce smoking by restoring flexibility to valve stem seals for improved sealing, also providing outstanding upper cylinder lubricity as it frees up sticking rings
• Inhibits oxidation and extends engine oil life (see TFOUT test results below)
• Also use to extend the life of small 4 cycle engines such as; lawn maintenance equipment, motorcycles, snow mobiles, etc.

• EOS 30902 – 10 oz
• EOS 30901 – 15 oz
• EOS 40902 – 32 oz
• EOS 40904 – 5 gal
• EOS 40905 – 55 gal

Add 3 oz. of Bio/Tech for every quart of motor oil to the crank case. Can be added at any point in motor oil life. For best results, add to fresh oil during oil change.  10 oz. bottle treats one 3-1/2 quart system. 15 oz. bottle treats one 5 quart system.

The motor oil with the addition of LUBEGARD Bio-Tech Engine Protectant increased the oxidative stability of the untreated motor oil from 248 minutes to 349 minutes. This improvement in oxidative stability (29% improvement over untreated motor oil) is far greater than any of the other tested additives.

When you start your engine in the morning, it runs for up to 60 seconds on the oil film left from the night before. Scientific studies in operating engines have shown that the wear rates are close to 50 times greater during starting than during running. LUBEGARD® Bio/Tech Engine Protectant helps improve the protection of the oil film against wear start after start, as well as reducing friction and wear when the engine is running. Lowering friction within the engine restores lost energy to you in the form of improved gas mileage and higher performance when you need it most.

Pictured are steel pins from a Falex Pin and Vee Block test simulating start up conditions in motor oil. The Falex Pin and Vee Block test measures the sliding friction and wear of a round metal cylinder on flat metal block surfaces. Sliding friction is the major type of friction and wear in engines. The test pictured was run only for analysis of friction and wear of individual oils with and without LUBEGARD®.

Sliding friction/ energy loss occurs at start up in the:

• Main crankshaft bearings
• Connecting rod bearings
• Where the piston rings contact the
cylinder walls
• Where the push rods or lifters contact
the lobes of the cam shaft
• In the valve guides
• In the hydraulic valve lifters

Other tested Oils include:

Note: International Lubricants, Inc. does not compare, endorse, or advise comparison of any brands of motor oil on the basis of these tests.

Swissmotor, (Switzerland’s cross-version of AAA meets Car and Driver) did their own independent and unsolicited research and field testing on LUBEGARD products, including the Engine Oil Protectant. Read their amazing field tests and results in the full story here!

“If one considers how many millions are invested in development projects by vehicle manufacturers to increase engine power and at the same reduce fuel consumption, and then compares that amount to the ridiculously low cost of adding LUBEGARD, one can only shake one’s head in disbelief. Especially since LUBEGARD also significantly prolongs the operating life of any mechanism.”